Professional high-frequency cable designed for the frequency range 0 to 6 GHz. The cable with a length of 5m is terminated with crimped connectors, N male on one side and N male on the other. Due to low attenuation an

UbiBracket is universal positioning mount for mast or wall for all NanoStation and Loco devices. The holder can be attached to a pipe up to a diameter of 60mm.

The Gigabit PoE injector is used to power most RouteBOARDs or Ubiquiti devices supports passive PoE. This type comes with a standard size 2.1/5.5mm power connector. The PoE injector does not work with 802.3af standard and powering devices

ML-S+31D-10 is a singlemode 10G SFP+ module with 1310nm wave length and 2 LC connectors for link at distance up to 10km. Module is "cisco compatible", so it is compatible with almost all active devices.

MaxLink PI15 is Gigabit PoE injector with very good quality and one output POE port for powering devices supporting 802.3af with maximum power consumption up to 15,4W. The power supply is guided over 4,5 (+) and 7,8 (-) wires. PoE injector is su

ML-S31D-20 is 1.25G SFP module with wave length 1310nm, 2 LC connectors for maximal distance 20km with singlemode fiber. SFP module supports DDM - digital diagnostics monitoring. The LC connectors in the SFP module have UPC type grinding.

MaxLink PI30 is Gigabit PoE injector with very good quality and one output POE port for powering devices supporting 802.3af/at with maximum power consumption up to 30W. The power supply is guided over 4,5 (+) and 7,8 (-) wires. PoE injector is s

ML-S+2733-10 is singlemode 10G SFP+ module with 1 LC connector for link at distance up to 10km. It uses 1 optical fiber, Tx/Rx wave length is 1270/1330nm. Module is "cisco compatible", so it is compatible with almost all active dev

ML-S+3327-10 is singlemode 10G SFP+ module with 1 LC connector for link at distance up to 10km. It uses 1 optical fiber, Tx/Rx wave length is 1330/1270nm. Module is "cisco compatible", so it is compatible with almost all active dev

MaxLink PI60 is a high quality Gigabit POE injector with one POE output port for powering 802.3af/at/bt devices with maximum power consumption up to 60W. For better current load distribution, all 4 pairs of conductors are powered. The

ML-S+85D-03 is multimode 10G SFP+ module with 850nm wave length and 2 LC connectors for link at distance up to 300m. Module is "cisco compatible", so it is compatible with almost all active devices.

RF cable with very low loss of gain and great flexibility with a length of 25 cm and RSMA male - RSMA male connectors. The cable is suitable for both indoor and outdoor use - ideal for MikroTik BaseBox, UBNT Rocket and other products.

Pigtail with u.Fl and N female, 25cm long, designed for the frequency range 0 to 6GHz with attenuation of max 1.5dB. This is a quality reduction, eg for connection to miniPCI cards, etc.

ML-S85D-05 is 1.25G SFP module with wave length 850nm, 2 LC connectors for maximal distance 550m with multimode fiber. SFP module supports DDM - digital diagnostics monitoring. Modules are compatible with all MikroTik products and with others m

MaxLink 10G SFP+ Direct Attach Cable, passive is a fast and cheap solution for easily connecting two 1G or 10Gbps network switches/routers without the need for SFP/SFP+ modules or other accessories (for example optical patch cables). T

Passive PoE set of injector and extractor used to power most RouteBOARDs. It is a 100Mbps cable variant that can be used to power any device with a corresponding input power connector. The PoE set does not meet the IEEE 802.3af/at specifi

Lead-acid battery with 12V and 18Ah capacity. The battery is equipped with two M5 connectors to connect to the device. Estimated battery life is 10 years depending on installation conditions and battery usage. The

MaxLink 10G SFP+ Direct Attach Cable, passive is a fast and cheap solution for easily connecting two 1G or 10Gbps network switches/routers without the need for SFP/SFP+ modules or other accessories (for example optical patch cables). T

ML-SFP-RJ45-1G is RJ45 SFP 10/100/1000M copper module, compatible with most Gigabit SFP ports available on various networking devices. Maximum distance range is 100m.

MaxLink PI15S is high quality Gbit POE injector with 1 POE Out eth port for devices which support 802.3af. It provides 15,4W. Plug injector directly to socket. Powering through 4,5(+) and 7,8(-). It is suitable especially for IP cams, VOIP phone

MaxLink 10G SFP+ Direct Attach Cable, passive is a fast and cheap solution for easily connecting two 1G or 10Gbps network switches/routers without the need for SFP/SFP+ modules or other accessories (for example optical patch cables). T

PSBT-10-8P-250 is a 10 port 10/100Mbps PoE switch without management. Automatically detects and powers devices supporting PoE standard 802.3af/at (max. 30 W port) on ports 1 to 8, on port 1 it even supports PoE standard 802.3bt (60

ML-S31D-3 is 1.25G SFP module with wave length 1310nm, 2 LC connectors for maximal distance 3km with singlemode fiber. SFP module supports DDM - digital diagnostics monitoring. The LC connectors in the SFP module have UPC type grinding.

MaxLink 10G SFP+ Direct Attach Cable, passive is a fast and cheap solution for easily connecting two 1G or 10Gbps network switches/routers without the need for SFP/SFP+ modules or other accessories (for example optical patch cables). T

The ML-WAP-H is an improved ability to hold any MikroTik wAP unit on a 20-65mm diameter mast that allows elevation and a more stable hold than the plastic or metal strap. No drilling is required to install the MaxLink bracket on the wAP u

PSBT-6-4P-250 is a 6 port 10/100Mbps PoE switch without management. Automatically detects and powers devices supporting PoE standard 802.3af/at (max. 30 W/port) on ports 1 to 4, on port 1 even supports PoE standard 802.3bt (60 W).

MAXPIDIN-S is a single-port Gigabit surge protector from the MaxLink brand designed for indoor use and modern installation on a DIN rail. This surge protector protects your device on all 8 pins and have no problem even with the PoE from w

ML-S28-MM-100 is a multi-mode SFP28 module with a wavelength of 850nm, a speed of 25 Gbps, 2x LC connectors and a maximum distance of 100m. SFP module supports DDM - digital diagnostics monitoring. The LC connectors in the SFP module have UPC

High quality 90° angle adapter with N-male and N-female connectors. Suitable for using with Groove or Bullet devices.

Cable reduction from MMCX to N female, 25 cm long, designated frequency range from 0 to 6 GHz with attenuation max 1,5 dB. Connector MMCX is rotated to 90°. High quality reduction used for example for connection between miniPCI cards, e